 AirForce 250ci Plasma Cutter
Model #500534
This plasma cutter is ready to go right out of the box. The AirForce 250ci operates off of standard household current and has a built in piston driven air compressor. A very convenient and portable
plasma cutter at a very economical price.
Hobart Welders has this plasma cutter rated to cut 1/8" steel at ten inches per minute travel speed. However, if you slow down your travel speed and use proper technique you can cut up to 3/16" steel and still achieve a good quality cut.
This plasma cutter
comes straight from the factory with a 16.5 foot HP-25 hand held torch, 16.5 foot work clamp, 7 foot power cord with plug.
Cutting Thickness Chart*
- 1/8" Clean Cut (Steel)
- 1/4" (Sever-Steel)
- 1/16" Stainless
- 1/16" Aluminum
- 1/16" Galvanized
- 1/16" Brass
- 1/16" Copper
*Ratings based on 10in/min. Can sever max. thickness with new consumables and proper technique.
|
